Fourth of July "Seeing Stars" Wreath
Tools and Materials
wire wreath form (spray painted cream- Valspar)
Martha Stewart brand craft paints in red and blue
paint brush
craft mat (optional)
wooden stars assorted size (comes in a pack)
buttons in red, white, and blue
sandpaper
craft drill with piece of wood to drill into
19- 21 gauge wire
wire cutter
coordinating ribbon
Step One: Paint the wreath with the red and blue craft paints as shown in top pic. The reason I recommend the MS paint here is that it will adhere to the metal of the frame. It takes a week or so to cure completely but they'll be dry to the touch within 10 minutes.I painted loosely, not covering the frame completely. Set aside.
Step Two:Paint your wooden stars. I used 3 large stars, 5 medium stars, and 2 small stars.Sand the edges of the stars once dry, if desired.
Step Three: Using your craft drill or regular drill with small bit, drill a hole in the center of each star.
Step Four: Cut a 4-5" piece of the thin wire and bend over like a hairpin. Then, thread through button from top and insert both wires through hole in center of the star.
Step Five: Wire your stars to the wire wreath frame where desired, or you can check out my placements in the pic.You could also stack the stars for a more elaborate look.
Step Six: Add your ribbon and you're done!
Some ideas for altering the design would be to add a wire word like freedom, maybe adding some wire stars made from 16-gauge steel wire, or doing a cute little fabric pennant across the center that says something patriotic, instead of the ribbon. Fourth of July ribbon is super cheap at the craft stores right now, and will get cheaper in the next few days. But play around, make one like mine, or make your own! Just have fun and Enjoy the Fourth!!!!!
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.